|
| |
TM 10-4320-311-14
6-2. Special Tools, TMDE, and Support Equipment. The special tools required to service the pumping unit are listed
and illustrated in TM 10-4320-311-24P, Repair Parts and Special Tools List (RPSTL), and in the Maintenance Allocation
Chart (MAC) located in Appendix B of this manual.
6-3. Repair Parts. Repair parts are listed and illustrated in TM 10-4320-311-24P.
Section II. GENERAL SUPPORT MAINTENANCE PROCEDURES
INDEX
Para
Page
6-4
General instructions ......................................................................................................
6-2
6-5
Replace/inspect/repair cylinder head and valve assembly.............................................
6-3
6-6
Replace/inspect/repair crankcase cover ........................................................................
6-8
6-7
Replace/inspect/repair lube oil pump ............................................................................
6-11
6-8
Replace/inspect camshaft .............................................................................................
6-14
6-9
Replace/inspect balancer shaft .....................................................................................
6-18
6-10
Replace/inspect/repair piston and connecting rod assembly ..........................................
6-20
6-11
Inspect/replace flywheel................................................................................................
6-26
6-12
Replace/inspect crankshaft ...........................................................................................
6-28
6-13
Replace/inspect governor and speed control device......................................................
6-30
6-14
Replace/inspect crankcase............................................................................................
6-34
6-4. General Instructions.
a.
Unless otherwise stated, one person can perform the task listed.
b.
The normal standard equipment condition to start a maintenance task is engine stopped.
c.
Refer to Appendix G to determine torque requirements when tightening threaded fasteners, unless a specific
torque value Is given in the procedure. Torque values in Appendix G are determined by thread size.
6-2
|
