|
| |
TM 10-4320-311-14
5-12. Replace/Inspect Diesel Engine.
This task covers:
a.
Removal
b.
Inspection
c.
Installation
INITIAL SETUP
Tools
Equipment
Condition
Tool Kit, General Mechanics (Item 1,
Para
Appendix B, Section III)
4-21
Crankcase oil heater removed.
Material/Parts
4-25
Fuel tank removed.
Gasket for Oil Drain, 43400-500490
5-11
Pump casing removed.
REMOVAL: Refer to Figure 5-3.
a.
Remove oil drain plug (1) and drain engine oil.
b.
Remove oil drain hose (2) from oil drain on engine (3). Discard gasket.
c.
Remove four nuts (4) attaching engine to engine base plate (5)
d.
Remove engine from engine base plate.
INSPECTION:
a.
Wipe surface areas with clean, dry cloth.
WARNING
When using compressed air, always use chip guards and wear eye protection.
b.
Inspect all surfaces and edges for cracks.
c.
Blow out suspicious looking and difficult to reach areas with compressed air to remove deposits and reveal flaws
INSTALLATION:
a.
Mount engine to engine base plate (5) and secure with four nuts (4).
b.
Install oil drain hose (2) with new gasket to engine (3) oil drain.
c.
Install oil drain plug (1).
5-10
|
