|
| |
TM 10-4320-311-14
REMOVAL: Refer to Figure 4-29.
a.
Loosen and remove wing nut (1)
b.
Detach air cleaner housing cover (2).
c.
Remove air cleaner element (3).
d.
Remove hex nuts (4) securing the air cleaner housing (5).
e.
Remove air cleaner housing (5). Discard gasket (6).
INSPECTION/REPAIR:
a.
Check that air cleaner housing (5) and cover (2) are free from dirt.
b.
Check air cleaner housing (5) and cover (2) for damage. Replace if necessary.
c.
Check air restriction indicator (7) for damage. Replace if necessary.
d.
Check air intake hose (8) for damage. Replace if necessary.
e.
Remove hex bolt (9) and air intake bend (10) Discard gasket (11).
INSTALLATION:
CAUTION
Never run the engine without the air cleaner element. Rapid engine wear may result.
a.
Place new gasket (11) In place, position air intake bend (10), and secure with hex bolt (9).
b.
Place new gasket (6) on intake manifold studs.
c.
Place air cleaner housing (5) over studs and secure with hex nuts (4).
d.
Install air cleaner element (3) into air cleaner housing (5).
e.
Replace air cleaner housing cover (2).
f.
Replace and tighten wing nut (1)
g.
Reset the air cleaner restriction indicator by depressing the black button on top
4-56
|
