|
| |
TM 10-4320-256-14&P
Section Il. SERVICE UPON RECEIPT
Paragraph
Page
4-4
Inspection
4-2
4-5
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..4-2
4-6
Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . 4-2
4-7
Testing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-2
4-8
Dismanting for Movement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-3
4-4. Inspection.
a. Make a compiete and thorough visual inspection of the equipment,checking for loss ordamagewhichmay
have occurr shipment.
b. inspect the engine accessories to make sure they are securely mounted and in good working condition.
c. inspect all controls to make sure they are intact working properly.
4-5. Installation.
. . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . .. . .. .
(1)
(2)
(3)
If possibile, chose a location that is free of excess moisture and dust.
install the pump assembly as level as possible. Provide ampiespace on all sides of the equipment for
access in servicing. If possibie, provide a suitable rigid foundation.
If equipment is to be installed inside a building, make sure adequate ventilation is provided to carry off
engine exhaust gases.
b
(1)
(2)
(3)
(4)
WARNING
Weight of the pump exceeds one person lift limit. Maximum height of lift for two persons
is 2.8 feet (85.3 centimeter).
Remove the pump assembly from the carrier and place it in position.
Locate the pump so as to keep the suction line as short as possible.
Connect the suction and discharge lines (para. 2-9b and 2-9c).
Ground the puump assembly (para. 2-9d).
4-6. Lubrication. Refer to lubrication instructions, Chapter 3, Section i, and service the engine.
4-7. Testing. Perform unit level PMCS and operator Before (B) PMCS before operating pump assembly.
Operate equipment (Chapter 2, Section III) for at least 15 minutes. Observe the equipment during operation. if
any malfunctions arise, troubleshoot in accordance with Section IV.
4-2
|
