|
| |
TM 10-3835-231-13
Section III. OPERATION UNDER USUAL CONDITIONS
2-4. ASSEMBLY AND PREPARATION FOR USE.
The services of Unit Maintenance should be used for original unpacking, installation and preparation for use.
2-5. INITIAL ADJUSTMENTS AND CHECKS.
a.
Inspect total system for obvious damage or installation problems.
b.
Check that all valves are closed.
c.
Perform the preventative maintenance checks and services listed in table 2-1.
d.
Report any deficiencies to unit maintenance.
2-6. OPERATING PROCEDURES.
a.
General Safety.
The following is a summary of general safe work practices that should be followed to avoid personnel injury and
equipment damage. When operating specific equipment and systems, refer to applicable manuals for additional warnings
and cautions.
WARNING
NO SMOKING
No smoking allowed within 50 ft. of any facility or device storing or handling
petroleum fuels.
WARNING
MOVING PARTS
Engines and pumps have fast moving parts that can injure hands, feet etc. Take
special care while in operation.
WARNING
HOT ENGINE PARTS
Engine parts, particularly the exhaust system can be very hot and cause severe
burns. Do not touch until engine is shut down and cooled off. Avoid spilling
fuel or oil on engine parts which could result in a fire.
2-38
|
