|
| |
T M 1 0 - 3 8 3 5 - 2 1 9 - 1 4
(h) Apply a coat of rubber cement to shank of adapter (5).
CAUTION
If it is necessary to pound adapter into hose end, place a wood block over
sealing face of adapter to prevent damage to adapter.
(i)
Immediately insert adapter (5) into hose end (4). Push adapter into hose until hose end
contacts shoulder of adapter as shown.
(j)
Apply rubber cement to cut (raw) area of hose end (6).
(k)
Apply a coat of rubber cement to shank on other end of adapter (5).
CAUTION
To prevent damage to hose, do not pound adapter into remaining hose
e n d.
(l)
( m)
(n)
(o)
(p)
(q)
Immediately insert adapter (5) into hose end (6). Push adapter into hose until hose end
contacts shoulder of adapter as shown.
Position three clamp sections (7) around hose end (4) and adapter (5). Make sure clamp
sections mate with groove in adapter as shown.
Install three bolts (9) and nuts (8) to secure clamp sections (7) to adapter (5).
Repeat steps (7) and (8) to install repair clamp (10) on hose end (6).
Remove hose clamps (1 and 2).
Test repaired section of hose for leaks.
Change 1
3-12.3/(3-12 .4 Blank)
|
