OIL CAN POINTS - LO-10-4320-343-120006

LO 10-4320-343-12

c. Remove cotter pin.

d. Remove axle nut and washer.

e. Remove outer bearing and hub.

f. Remove grease seal and inner bearing.

g. Degrease all parts.

h. Pack bearings with grease prescribed in key.

i. Install inner bearing and seal.

j. Install outer bearing and hub.

k Install axle nut and washer.

l. Install cotter pin.

m. Install grease cap.

6. OIL CAN POINTS. Every 50 hours clean and lightly oil the following:

(1)

Control Panel Hinge.

Control Panel lock.

(2)

Tool Box Hinge.

(3)

Tool Box. Latch.

(4)

Battery Cover Latch.

(5)

7. PUMP BEARING CAVITY. Remove drain plug at bottom of intermediate bracket to drain oil. Clean and install

drain plug. Remove vent fitting and fill with 8 ounces (236.56cc) of OE/HDO oil. Install vent fitting.

8. ENGINE CRANKCASE OIL LEVEL. Check oil level dipstick for FULL indication. To add oil, remove filler cap

and add OE/HDO to bring level to FULL mark on dipstick, remove plug in bottom of crankcase sump and drain

required amount. Check oil level.

Card 6 of 7