Lubricate Speed Reducer

LO 10-4320-342-12

Lubricate Speed Reducer per one of steps below:

Check level of lubricant (before starting) per steps below:

(1) Shut down 200/600 GPM Flammable Liquid Low Temperature Pump if operating.

(2) Remove level indicator cap, pull up on indicator until magnetic field holds indicator.

NOTE

If level indicator shows 1 to 8 add lubricant (2-1/2 marks

on indicator equals one quart)

(3) Add lubricant per Table 3, if level indicator is below 8-1/2.

(4) Push down on indicator and install level indicator cap.

Drain and refill lubricant (semiannually) per steps below:

(1)

Shut down 200/600 GPM Flammable Liquid Low Temperature Pump if operating.

(2)

Place container (to hold lubricant) under drain.

(3)

Remove drain cap.

(4)

Remove fill cap.

(5)

Install drain cap after lubricant has drained.

(6)

Replace oil filter, refer to TM 10-4320-342-24.

(7)

Add lubricant per Table 3.

(8)

Install fill cap.

Copy of this Lubrication Order will remain with the equipment at all times; instructions contained herein are

mandatory.

By Order of the Secretary of the Army:

DENNIS J. REIMER

General, United States Army

Official:

Chief of Staff

JOEL B. HUDSON

Acting Administrative Assistant to the

Secretary of the Army

01640

DISTRIBUTION:

To be distributed in accordance with DA Form 12-25-E, block no. 6343, requirements for LO 10-4320-342-

12.

Card 7 of 7